Cisco UC500 series Panduan Konfigurasi - Halaman 39

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Sistem Konferensi Cisco UC500 series. Cisco UC500 series 50 halaman. Sip trunking unified communications 500 series

Halaman Cetak

4.3.29 After the configuration is applied – this is now part of the running configuration

and will not survive a reload. To ensure the configuration is saved to NVRAM – click on

"Save Configuration"

on the left as shown previously

Figure 4.3.29 Saving configuration

This completes the CCA configuration for the UC500 SIP trunking portion. There are a

few commands that need to be entered via CLI depending on call flows that do not work.

Please see the CLI section below.

4.4

CLI configuration

This is an optional step if calls do not work. This section will cover some of the more

common scenarios or call flows that config will need to added / changed via CLI on the

UC500. Please note that there are efforts underway to add some of these options into the

CCA tool in which case the below CLIs will not be required.

4.4.1 Access UC500 via CLI

Open an ssh or telnet session to 192.168.10.1 (using an application such as Putty from the

same PC that CCA was launched from). The username / password should be what you