ACU-RITE 06087 Buku Petunjuk - Halaman 10

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Monitor ACU-RITE 06087. ACU-RITE 06087 16 halaman. Professional weather display

High & Low Records

High and low records reflect the minimum and maximum temperature and

humidity recorded since the unit was powered on, since the batteries were

replaced, or since the records were manually reset (whichever was most

recent).

To view the LOW records, press and release the " " button. The low record

indicator appears on the display next to the low records.

To view the HIGH records, press and release the " " button. The high record

indicator appears on the display next to the high records.

To reset the LOW records, press AND HOLD the " " button while viewing the

low records. Dashes will display to confirm all low records have been reset.

To reset the HIGH records, press AND HOLD the " " button while viewing

the high records. Dashes will display to confirm all high records have been

reset.

Calibration

The indoor/outdoor temperature and humidity readings, and barometric pressure can

be calibrated on the display unit to improve accuracy. Calibration can improve accuracy

when sensor placement or environmental factors impact the data accuracy.

1. To access calibration mode, press AND HOLD the "

buttons simultaneously for at least 5 seconds.

2. To adjust the currently selected (flashing) item, press and release the "

buttons to calibrate the data value higher or lower than the actual reading.

3. To save your adjustments, press and release the " OK " button to adjust the next

preference. The "

The preference set order is as follows:

OUTDOOR TEMPERATURE

OUTDOOR HUMIDITY

INDOOR TEMPERATURE

INDOOR HUMIDITY

BAROMETRIC PRESSURE (must be set to MANUAL mode to calibrate)*

*To change from AUTO to MANUAL pressure mode and vice versa, press

AND HOLD the " " button for 10 seconds. "auto" will disappear above the

barometric pressure to indicate that manual mode has been activated. Press and

HOLD the " " button for 10 seconds to return to AUTO mode.

After 10 seconds of inactivity, the display will save the adjustments and exit

calibration mode. Note: Calibrations will be erased if the display is reset or if

batteries are removed and the power adapter is unplugged.

" icon will remain illuminated next to calibrated values.

," " OK ," and "

" or "