Cisco 3020 - Cisco Catalyst Blade Switch Panduan Memulai - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Perangkat Keras Jaringan Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37 halaman. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Juga untuk Cisco 3020 - Cisco Catalyst Blade Switch: Panduan Memulai (31 halaman), Quickspecs (12 halaman), Catatan Rilis (41 halaman), Catatan Rilis (27 halaman), Catatan Rilis (23 halaman), Catatan Rilis (21 halaman), Panduan Instalasi (21 halaman)

Cisco 3020 - Cisco Catalyst Blade Switch Panduan Memulai
Press and hold the Mode button until the four LEDs next to the Mode button turn green. This
Step 4
takes approximately 3 seconds.
S Y S T
S T A T
D L X
S P D
M O D E
C O N S
W S - C B
O L E
S - 3 0 2 0
- H P Q
1
Mode button
1
Release the Mode button.
Step 5
If the LEDs next to the Mode button begin to blink after you press the button, release it.
Blinking LEDs mean that the switch module has already been configured and cannot go into
Express Setup mode. For more information, see the "Resetting the Switch Module" section on
page 23.
Connect a straight-through Category 5 Ethernet cable (not provided) to any Ethernet port on
Step 6
the switch module front panel and to the Ethernet port on the PC. (See Figure 5.)
12
1 7
U I D
2 0
1 7