Cisco 3020 - Cisco Catalyst Blade Switch Manuale introduttivo - Pagina 12

Sfoglia online o scarica il pdf Manuale introduttivo per Hardware di rete Cisco 3020 - Cisco Catalyst Blade Switch. Cisco 3020 - Cisco Catalyst Blade Switch 37. Release notes for the cisco catalyst blade switch 3020 for hp, ciscoã‚â iosã‚â releaseã‚â 12.2(44)se
Anche per Cisco 3020 - Cisco Catalyst Blade Switch: Manuale introduttivo (31 pagine), Specifiche rapide (12 pagine), Nota di rilascio (41 pagine), Nota di rilascio (27 pagine), Nota di rilascio (23 pagine), Nota di rilascio (21 pagine), Manuale di installazione (21 pagine)

Stampa la pagina

Cisco 3020 - Cisco Catalyst Blade Switch Manuale introduttivo

Press and hold the Mode button until the four LEDs next to the Mode button turn green. This

Step 4

takes approximately 3 seconds.

S Y S T

S T A T

D L X

S P D

M O D E

C O N S

W S - C B

O L E

S - 3 0 2 0

- H P Q

Mode button

Release the Mode button.

Step 5

If the LEDs next to the Mode button begin to blink after you press the button, release it.

Blinking LEDs mean that the switch module has already been configured and cannot go into

Express Setup mode. For more information, see the "Resetting the Switch Module" section on

page 23.

Connect a straight-through Category 5 Ethernet cable (not provided) to any Ethernet port on

Step 6

the switch module front panel and to the Ethernet port on the PC. (See Figure 5.)

1 7

U I D

2 0

1 7