Cisco 5500 Series Panduan Instalasi - Halaman 26
Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perangkat Keras Jaringan Cisco 5500 Series. Cisco 5500 Series 34 halaman. Cisco 8500 series
wireless lan controller
Juga untuk Cisco 5500 Series: Panduan Konfigurasi (40 halaman), Manual (19 halaman), Panduan Konfigurasi (50 halaman)
Halaman Cetak
Using the Startup Wizard
If you want the controller to receive its time setting from an external Network Time Protocol (NTP)
Step 17
server when it powers up, enter yes to configure an NTP server. Otherwise, enter no.
Step 18
If you entered no in the previous step and want to manually configure the system time on your controller
now, enter yes. If you do not want to configure the system time now, enter no.
Step 19
If you entered yes in the previous step, enter the current date in MM/DD/YY format and the current time
in HH:MM:SS format.
When prompted to verify that the configuration is correct, enter yes or no.
Step 20
The controller saves your configuration, reboots, and prompts you to log in.
Logging into the Controller
Follow these steps to log into the controller.
Enter a valid username and password to log into the controller CLI.
Step 1
Note
The CLI displays the root level system prompt:
Step 2
#(system prompt)>
The system prompt can be any alphanumeric string up to 31 characters. You can change it by entering
the config prompt command.
Note
Note
Cisco 5500 Series Wireless Controller Installation Guide
26
The administrative username and password you created in the Startup Wizard are case sensitive.
The CLI automatically logs you out without saving any changes after 5 minutes of inactivity.
You can set the automatic logout from 0 (never log out) to 160 minutes using the config serial
timeout command.
Cisco Aironet lightweight access points do not connect to the Cisco 5500 Series Wireless
Controller if the date and time are not set properly. Set the current date and time on the controller
before allowing the access points to connect to it.
78-18998-01