Cisco 5500 Series 설치 매뉴얼 - 페이지 26

{카테고리_이름} Cisco 5500 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5500 Series 34 페이지. Cisco 8500 series wireless lan controller
Cisco 5500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 매뉴얼 (19 페이지), 구성 매뉴얼 (50 페이지)

페이지 인쇄

Using the Startup Wizard

If you want the controller to receive its time setting from an external Network Time Protocol (NTP)

Step 17

server when it powers up, enter yes to configure an NTP server. Otherwise, enter no.

Step 18

If you entered no in the previous step and want to manually configure the system time on your controller

now, enter yes. If you do not want to configure the system time now, enter no.

Step 19

If you entered yes in the previous step, enter the current date in MM/DD/YY format and the current time

in HH:MM:SS format.

When prompted to verify that the configuration is correct, enter yes or no.

Step 20

The controller saves your configuration, reboots, and prompts you to log in.

Logging into the Controller

Follow these steps to log into the controller.

Enter a valid username and password to log into the controller CLI.

Step 1

Note

The CLI displays the root level system prompt:

Step 2

#(system prompt)>

The system prompt can be any alphanumeric string up to 31 characters. You can change it by entering

the config prompt command.

Note

Cisco 5500 Series Wireless Controller Installation Guide

The administrative username and password you created in the Startup Wizard are case sensitive.

The CLI automatically logs you out without saving any changes after 5 minutes of inactivity.

You can set the automatic logout from 0 (never log out) to 160 minutes using the config serial

timeout command.

Cisco Aironet lightweight access points do not connect to the Cisco 5500 Series Wireless

Controller if the date and time are not set properly. Set the current date and time on the controller

before allowing the access points to connect to it.

78-18998-01