Cisco 5500 Series 설치 매뉴얼 - 페이지 24

{카테고리_이름} Cisco 5500 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 5500 Series 34 페이지. Cisco 8500 series wireless lan controller
Cisco 5500 Series에 대해서도 마찬가지입니다: 구성 매뉴얼 (40 페이지), 매뉴얼 (19 페이지), 구성 매뉴얼 (50 페이지)

페이지 인쇄

Using the Startup Wizard

If the controller passes the power-on self test, the bootup script runs the Startup Wizard, which prompts

Step 6

you for basic configuration input.

Using the Startup Wizard

Before you can use the startup wizard, you must obtain the information discussed in the

and Information" section on page

The available options appear in brackets after each configuration parameter. The default value appears

Note

in all uppercase letters.

Press the hyphen key if you need to return to the previous command line.

Note

To configure the controller for basic operation using the Startup Wizard, follow these steps:

When prompted to terminate the AutoInstall process, enter yes. If you do not enter yes, the AutoInstall

Step 1

process begins after 30 seconds.

Note

Enter the system name, which is the name you want to assign to the controller. You can enter up to

Step 2

32 ASCII characters.

Enter the administrative username and password to be assigned to this controller. You can enter up to 24

Step 3

ASCII characters for each. The default administrative username and password are admin and admin,

respectively.

Step 4

If you want the controller's service-port interface to obtain an IP address from a DHCP server, enter

DHCP. If you do not want to use the service port or if you want to assign a static IP address to the

service-port interface, enter none.

Note

If you entered none in

Step 5

two lines.

Enable or disable link aggregation (LAG) by choosing yes or no.

Step 6

Enter the IP address, netmask, default router IP address, and optional VLAN identifier (a valid VLAN

Step 7

identifier or 0 for an untagged VLAN) for the management interface.

Cisco 5500 Series Wireless Controller Installation Guide

The AutoInstall feature downloads a configuration file from a TFTP server and then loads the

configuration onto the controller automatically.

The service-port interface controls communications through the service port. Its IP address must

be on a different subnet from the management interface. This configuration enables you to

manage the controller directly or through a dedicated management network to ensure service

access during network downtime.

Step

4, enter the IP address and netmask for the service-port interface on the next

"Required Tools

78-18998-01