Cisco 7513 Series Panduan Memulai Cepat - Halaman 29

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco 7513 Series. Cisco 7513 Series 44 halaman. Chassis replacement
Juga untuk Cisco 7513 Series: Manual Petunjuk Penggantian (26 halaman), Lembar data (11 halaman), Manual (30 halaman), Mempertahankan (20 halaman), Manual Petunjuk Penggantian (19 halaman), Manual Petunjuk Penggantian (22 halaman)

Halaman Cetak
Cisco 7513 Series Panduan Memulai Cepat
Install Field Replaceable Units (FRUs)
Remove and Install an Interface Processor, Filler, VIP, or RSP
A
Card
carrier
Captive
guide
installation
screw
B
C
Bottom ejector lever
Card
slot
STOP!
on contact
Note
Do not shut down the system power when
removing an interface processor, VIP, or an RSP in a
system configured for HA. If you are removing an
RSP and have only one RSP, shut down the system,
but first copy the configuration file to a TFTP server.
See the "Copy the Configuration File for an RSP"
section on page 31. If you have a system using high
system availability (HSA), shut down the system to
remove the master RSP, but leave power on if you
remove only the slave RSP.
Step 1
Attach an ESD-preventive wrist strap
between you and any unpainted chassis
surface.
Step 2
If you have a VIP4 and are using HSA
with an RSP2 as the slave processor,
remove the RSP2 and wait 20-30 seconds.
Step 3
Disconnect all cables from the interface
processor, VIP, or RSP port adapters;
unless you are only moving a carrier, then
skip this step.
Step 4
Use a screwdriver to loosen the captive
installation screws, as shown in A.
Step 5
Place your thumbs on both ejector levers
and simultaneously pull them both
outward, as shown in B.
Step 6
Grasp the interface processor, filler, VIP,
or RSP handle with one hand and pull the
carrier straight out of the slot, keeping
your other hand under the carrier to guide
it.
Step 7
Store the interface processor, VIP, or RSP
in an antistatic bag.
27