Cisco 7513 Series 빠른 시작 매뉴얼 - 페이지 29

{카테고리_이름} Cisco 7513 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 7513 Series 44 페이지. Chassis replacement
Cisco 7513 Series에 대해서도 마찬가지입니다: 교체 지침 매뉴얼 (26 페이지), 데이터시트 (11 페이지), 매뉴얼 (30 페이지), 유지 관리 (20 페이지), 교체 지침 매뉴얼 (19 페이지), 교체 지침 매뉴얼 (22 페이지)

페이지 인쇄

Install Field Replaceable Units (FRUs)

Remove and Install an Interface Processor, Filler, VIP, or RSP

Card

carrier

Captive

guide

installation

screw

Bottom ejector lever

Card

slot

STOP!

on contact

Note

Do not shut down the system power when

removing an interface processor, VIP, or an RSP in a

system conﬁgured for HA. If you are removing an

RSP and have only one RSP, shut down the system,

but ﬁrst copy the conﬁguration ﬁle to a TFTP server.

See the "Copy the Conﬁguration File for an RSP"

section on page 31. If you have a system using high

system availability (HSA), shut down the system to

remove the master RSP, but leave power on if you

remove only the slave RSP.

Step 1

Attach an ESD-preventive wrist strap

between you and any unpainted chassis

surface.

Step 2

If you have a VIP4 and are using HSA

with an RSP2 as the slave processor,

remove the RSP2 and wait 20-30 seconds.

Step 3

Disconnect all cables from the interface

processor, VIP, or RSP port adapters;

unless you are only moving a carrier, then

skip this step.

Step 4

Use a screwdriver to loosen the captive

installation screws, as shown in A.

Step 5

Place your thumbs on both ejector levers

and simultaneously pull them both

outward, as shown in B.

Step 6

Grasp the interface processor, ﬁller, VIP,

or RSP handle with one hand and pull the

carrier straight out of the slot, keeping

your other hand under the carrier to guide

it.

Step 7

Store the interface processor, VIP, or RSP

in an antistatic bag.