Argo Wallner MR 2212 C4 Buku Petunjuk - Halaman 14

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Mesin Penghancur Kertas Argo Wallner MR 2212 C4. Argo Wallner MR 2212 C4 16 halaman.

Halaman Cetak

SERVICE

Proceed only with routine actions according to the manual. Do not repair or service

machines on your own. Unplug the machine from the circuit and contact seller when one

or more of the following faults occur:

•

liquid gets into the machine

•

machine malfunctions as a result of improper use

•

machine does not work accordingly to the manual

PROBLEM SOLVING

problems

No operation

No operation after

long time operation

Excess squeaking

and rubbing noise

Paper jam

MALFUNTION / MAINTENANCE

If any faults should appear, please pass the machine along with the warranty card to the

seller or closest authorised dealer. The machine might be passed further, thus the user

should maintain the original and complete packaging. In cases when the machine is

passed for repair in a not original or incomplete package, the risks of further damages that

might arise in transportation are on the user's side. Thus, in such a case, it is in the user's

best interest to make the best possible replacement packaging.

checklists

The power plug is properly

inserted to main supply?

Switch is set at „I" position?

No operation when insert paper?

Checked above but no operation

and no power light.

Overheat light is on?

Without oiling to the cutting

system periodically.

- Squeaking and rubbing noise at

shredding.

- Exceeding the shredding

capacity

- The paper is not fed squarely

into the feed opening.

solutions

Fully put the power plug to the

outlet.

Press the Power button

Paper should be inserted to

trigger the sensor at center.

Send back to your local service

for repair.

Unplug the machine from

main supply. Allow to cool

down to room temperature

and resuming operation.

Perform the cutter oiling

instruction to lubricate the

cutting system.

Set switch to „Rev" for reverse

running and frees excess

paper. Then set to „I" for cutting

the remainder of paper left in

the cutting system. If serious

jim occurred, send back to

local service for repair.