Argo Wallner MR 2212 C4 사용 설명서 - 페이지 14
{카테고리_이름} Argo Wallner MR 2212 C4에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Argo Wallner MR 2212 C4 16 페이지.
SERVICE
Proceed only with routine actions according to the manual. Do not repair or service
machines on your own. Unplug the machine from the circuit and contact seller when one
or more of the following faults occur:
•
liquid gets into the machine
•
machine malfunctions as a result of improper use
•
machine does not work accordingly to the manual
PROBLEM SOLVING
problems
No operation
No operation after
long time operation
Excess squeaking
and rubbing noise
Paper jam
MALFUNTION / MAINTENANCE
If any faults should appear, please pass the machine along with the warranty card to the
seller or closest authorised dealer. The machine might be passed further, thus the user
should maintain the original and complete packaging. In cases when the machine is
passed for repair in a not original or incomplete package, the risks of further damages that
might arise in transportation are on the user's side. Thus, in such a case, it is in the user's
best interest to make the best possible replacement packaging.
© ARGO S.A.
EN
checklists
The power plug is properly
inserted to main supply?
Switch is set at „I" position?
No operation when insert paper?
Checked above but no operation
and no power light.
Overheat light is on?
Without oiling to the cutting
system periodically.
- Squeaking and rubbing noise at
shredding.
- Exceeding the shredding
capacity
- The paper is not fed squarely
into the feed opening.
14
solutions
Fully put the power plug to the
outlet.
Press the Power button
Paper should be inserted to
trigger the sensor at center.
Send back to your local service
for repair.
Unplug the machine from
main supply. Allow to cool
down to room temperature
and resuming operation.
Perform the cutter oiling
instruction to lubricate the
cutting system.
Set switch to „Rev" for reverse
running and frees excess
paper. Then set to „I" for cutting
the remainder of paper left in
the cutting system. If serious
jim occurred, send back to
local service for repair.
www.argo.pl