Cisco Aironet 340 Series Catatan Rilis - Halaman 2

Jelajahi secara online atau unduh pdf Catatan Rilis untuk Perangkat Keras Jaringan Cisco Aironet 340 Series. Cisco Aironet 340 Series 14 halaman. Usb client adapter
Juga untuk Cisco Aironet 340 Series: Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (13 halaman), Panduan Memulai Cepat (16 halaman), Panduan Memulai Cepat (12 halaman), Panduan Memulai Cepat (12 halaman)

Introduction

A Cisco Aironet Access Point is a wireless LAN transceiver that can act as the connection point between

wireless and wired networks or as the center point of a standalone wireless network. Cisco Aironet

Bridges are wireless LAN transceivers that connect two or more remote networks into a single LAN.

The access point and bridge use a browser-based management system. The system settings are on web

pages in the system firmware. You use your Internet browser to view and adjust the system settings.

You can find the latest release of access point and bridge firmware at this URL:

http://www.cisco.com/public/sw-center/sw-wireless.shtml

Installation in Environmental Air Space

Cisco Aironet 350 Series Bridges and metal-case access points are suitable for use in environmental air

space in accordance with Section 300-22(c) of the National Electrical Code.

The Cisco Aironet Power Injector has a smaller operating temperature range (32 to 104

Caution

than the 350 series bridge and metal-case access point. The power injector is not intended for use in

extremely high or low temperatures or in environmental air spaces, such as above suspended ceilings.

For instructions on the proper installation and grounding of external antennas, refer to the National Fire

Protection Association's NFPA 70, National Electrical Code, Article 810, and the Canadian Standards

Association's Canadian Electrical Code, Section 54.

Warning

Do not locate the antenna near overhead power lines or other electric light or power circuits, or

where it can come into contact with such circuits. When installing the antenna, take extreme care

not to come into contact with such circuits, as they may cause serious injury or death.

Power Considerations

The operational voltage range for 350 series access points and bridges is 24 to 60 VDC, and the nominal

Caution

voltage is 48 VDC. Voltage higher than 60 VDC can damage the equipment.

Cisco Aironet power injectors are designed for use with 350 series access points and 350 series bridges

Caution

only. Do not use the power injector with any other Ethernet-ready device. Using the power injector with

other Ethernet-ready devices can damage the equipment.

Release Notes for Cisco Aironet 340 and 350 Series Access Points and 350 Series Bridges Running Firmware Version 12.01T1

F; 0 to 40

OL-3740-01