Cisco ASA 5506W-X Panduan Konfigurasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Perangkat Keras Jaringan Cisco ASA 5506W-X. Cisco ASA 5506W-X 13 halaman. Threat defense reimage guide
Juga untuk Cisco ASA 5506W-X: Panduan Memulai Cepat (10 halaman), Panduan Memulai Cepat (14 halaman), Panduan Penyiapan yang Mudah (11 halaman), Manual Perangkat Lunak (37 halaman), Pasang dan Hubungkan (12 halaman), Panduan Instalasi (46 halaman), Memasang Sasis (10 halaman)

ASA + FirePOWER without an inside switch:

Configure

These steps must be performed in order after you power on and boot the ASA with the console

cable connected to the client.

Step 1. Modify Interface IP configuration on ASA

Configure the inside (GigabitEthernet 1/2) and wifi (GigabitEthernet 1/9) interfaces to have IP

addresses as needed within the existing environment. In this example, inside clients are on the

10.0.0.1/24 network and WIFI clients are on the 10.1.0.1/24 network.

asa(config)# interface gigabitEthernet 1/2

asa(config-if)# ip address 10.0.0.1 255.255.255.0

asa(config)# interface gigabitEthernet 1/9

asa(config-if)# ip address 10.1.0.1 255.255.255.0

Note: You will get this warning when you change the above interface IP addresses. This is

expected.

Interface address is not on same subnet as DHCP pool

WARNING: DHCPD bindings cleared on interface 'inside', address pool removed

Step 2. Modify DHCP pool settings on both inside and wifi interfaces

This step is required if the ASA is to be used as the DHCP server in the environment. If another

DHCP server is used to assign IP addresses to clients then DHCP should be disabled on the ASA

altogether. Since you have now changed our IP addressing scheme, you need to alter the existing

IP address ranges that the ASA is providing to clients. These commands will create new pools to

match the new IP address range:

asa(config)# dhcpd address 10.0.0.2-10.0.0.100 inside

asa(config)# dhcpd address 10.1.0.2-10.1.0.100 wifi

Also the modification of the DHCP pools will disable the previous DHCP server on the ASA, and