Cisco ASA 5506W-X Panduan Konfigurasi - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Perangkat Keras Jaringan Cisco ASA 5506W-X. Cisco ASA 5506W-X 13 halaman. Threat defense reimage guide
Juga untuk Cisco ASA 5506W-X: Panduan Memulai Cepat (10 halaman), Panduan Memulai Cepat (14 halaman), Panduan Penyiapan yang Mudah (11 halaman), Manual Perangkat Lunak (37 halaman), Pasang dan Hubungkan (12 halaman), Panduan Instalasi (46 halaman), Memasang Sasis (10 halaman)

you will need to re-enable it.

asa(config)# dhcpd enable inside

asa(config)# dhcpd enable wifi

If you do not change the interface IP addresses before making the DHCP changes then you will

receive this error:

asa(config)# dhcpd address 10.0.0.2-10.0.0.100 inside

Address range subnet 10.0.0.2 or 10.0.0.100 is not the same as inside interface subnet

192.168.1.1

Step 3. Specify DNS server to pass to inside and WiFI DHCP clients

When they assign IP addresses via DHCP, most clients also need to be assigned a DNS server by

the DHCP server. These commands will configure the ASA to include the DNS server located at

10.0.0.250 to all clients. You need to substitute the 10.0.0.250 for either an internal DNS server or

a DNS server provided by your ISP.

asa(config)# dhcpd dns 10.0.0.250 interface inside

asa(config)# dhcpd dns 10.0.0.250 interface wifi

Step 4. Modify HTTP access configuration on the ASA for Adaptive Security

Device Manager (ASDM) access:

Since the IP addressing has been changed, HTTP access to the ASA also needs to be modified

so that clients on the inside and WiFI networks can access ASDM to manage the ASA.

asa(config)# no http 192.168.1.0 255.255.255.0 inside

asa(config)# no http 192.168.10.0 255.255.255.0 wifi

asa(config)# http 0.0.0.0 0.0.0.0 inside asa(config)# http 0.0.0.0 0.0.0.0 wifi

Note: This configuration allows any client on the inside or wifi interfaces to access the ASA

via ASDM. As a security best practice, you must limit the scope of addresses to trusted

clients only.

Step 5. Modify Interface IP for Access Point Management in WLAN console

(interface BVI1):

asa# session wlan console

ap>enable

Password: Cisco

ap#configure terminal

Enter configuration commands, one per line.

ap(config)#interface BVI1

ap(config-if)#ip address 10.1.0.254 255.255.255.0

Step 6. Modify default-gateway on WAP

This step is required so that the WAP knows where to send all traffic that is not originated on the

local subnet. This is required to provide to access the WAP GUI via HTTP from a client on the

ASA inside interface.

End with CNTL/Z.