Argo SKY 350 Buku Petunjuk - Halaman 9

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Laminator Argo SKY 350. Argo SKY 350 12 halaman.

location and FUnction oF control

HOT

Use for Hot laminating. When pressed, temp 100 °C & Speed 4 is set automatically.

COLD

Use for Cold laminating. When pressed, temp & Speed 0 is set automatically.

SB (Stand By)

this function can be selected during intervals of long time operation. temp 80 °C and

speed 2 is set automatically.

MEAS

this function shows present temperature. the measured is displayed for 3 seconds.

STOP

this can be selected to stop revolution of the rollers.

to protect the rollers, please avoid manually stopping the rollers for a long period of time

when the temperature of the rollers is above 90 °C

REV.

this can be selected to reverse the revolution of the rollers.

in Correct of miss-feed and cleaning of the rollers can be done since the revolution is

reversed while this key is pressed.

°C/°F

Change °C to °F and vice versa.

How to memory

1. Press and Hold [mEm.] button until Beep sounds.

2. Press [mEm.] Button again mEmORY 1 2 3 One of 1, 2, 3 will blink.

3. Select designated temp and Speed using the [UP] and [DOWN] button.

4. After setting the proper temp and Speed, press [mEm.] to move next memory.

5. Press [REV.] button to complete memory insert.

6. to install different setting, start from step 2.

7. Press [COLD] to stop memory.

8. Press [mEm.] button to select proper memory slot.

TEMP.

Press the appropriate key to raise or lower

the temperature per requirement.

the setting range is 0-160 °C (32~320°F)

in 1 degree °C(°F) steps.

SPEED

Press the appropriate key to increase or

decrease the speed per requirement. the

setting range is 1-6 steps.

Nasza oferta w internecie: www.argo.pl