Argo SKY 350 Manuale di istruzioni - Pagina 9

Sfoglia online o scarica il pdf Manuale di istruzioni per Laminator Argo SKY 350. Argo SKY 350 12.

location and FUnction oF control

HOT

Use for Hot laminating. When pressed, temp 100 °C & Speed 4 is set automatically.

COLD

Use for Cold laminating. When pressed, temp & Speed 0 is set automatically.

SB (Stand By)

this function can be selected during intervals of long time operation. temp 80 °C and

speed 2 is set automatically.

MEAS

this function shows present temperature. the measured is displayed for 3 seconds.

STOP

this can be selected to stop revolution of the rollers.

to protect the rollers, please avoid manually stopping the rollers for a long period of time

when the temperature of the rollers is above 90 °C

REV.

this can be selected to reverse the revolution of the rollers.

in Correct of miss-feed and cleaning of the rollers can be done since the revolution is

reversed while this key is pressed.

°C/°F

Change °C to °F and vice versa.

How to memory

1. Press and Hold [mEm.] button until Beep sounds.

2. Press [mEm.] Button again mEmORY 1 2 3 One of 1, 2, 3 will blink.

3. Select designated temp and Speed using the [UP] and [DOWN] button.

4. After setting the proper temp and Speed, press [mEm.] to move next memory.

5. Press [REV.] button to complete memory insert.

6. to install different setting, start from step 2.

7. Press [COLD] to stop memory.

8. Press [mEm.] button to select proper memory slot.

TEMP.

Press the appropriate key to raise or lower

the temperature per requirement.

the setting range is 0-160 °C (32~320°F)

in 1 degree °C(°F) steps.

SPEED

Press the appropriate key to increase or

decrease the speed per requirement. the

setting range is 1-6 steps.

Nasza oferta w internecie: www.argo.pl