Sony MZ-R500 Panduan Petunjuk Pengoperasian - Halaman 35

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Sistem stereo Sony MZ-R500. Sony MZ-R500 40 halaman. Marketing specifications
Juga untuk Sony MZ-R500: Panduan Petunjuk Pengoperasian (40 halaman), Panduan Petunjuk Pengoperasian (20 halaman), Garansi Terbatas (1 halaman), Spesifikasi (2 halaman)

Sony MZ-R500 Panduan Petunjuk Pengoperasian

Messages

If the following error messages flash in the display window, check the chart below.
Error message
BLANK
ERROR
FULL
Saving
Edit
BUSY
FULL
HiDCin
HOLD
LoBATT
MEMORY
Meaning/Remedy
• An MD with no recording on it is inserted.
, Insert a recorded MD.
• The disc is damaged or does not contain proper recording or
editing data.
, Reinsert the disc. If this fails, rerecord.
• There is no more space to record on the disc (less than 12
seconds in stereo, 24 seconds in LP2 mode or monaural or 48
seconds in LP4 mode available).
, Replace the disc.
• The MD player is recording information (sounds) from the
memory to the disk.
, Wait until this process is completed. Do not expose the
player to any physical shock, nor disrupt power supply.
• The MD player is recording information (track start and end
position) from the memory to the disk.
, Wait until this process is completed. Do not expose the
player to physical shock, nor disrupt power supply.
• You tried to operate the recorder while it was accessing the
recorded data.
, Wait until the message goes out (in rare cases, it may take
2–3 minutes).
• You tried to enter more than 200 letters to label a single track
or disc.
• You tried to enter a total of more than 1,700 letters for track or
disc names during playback or stop.
, Enter the characters within the limit.
• Voltage of the power supply is too high (The recommended
AC power adaptor is not used).
, Use the recommended AC power adaptor.
• The recorder is locked.
, Slide HOLD against the arrow to unlock the recorder
(page 23).
• Battery is weak.
, Replace the dry battery (page 9).
• You tried to record with the recorder placed where it receives
continuous vibration.
, Put the recorder on a stable place, and start recording
again.
35
-GB