Sony MZ-R500 Instrukcja obsługi - Strona 35

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System stereo Sony MZ-R500. Sony MZ-R500 40 stron. Marketing specifications
Również dla Sony MZ-R500: Instrukcja obsługi (40 strony), Instrukcja obsługi (20 strony), Ograniczona gwarancja (1 strony), Specyfikacje (2 strony)

Drukuj stronę

Messages

If the following error messages flash in the display window, check the chart below.

Error message

BLANK

ERROR

FULL

Saving

Edit

BUSY

FULL

HiDCin

HOLD

LoBATT

MEMORY

Meaning/Remedy

• An MD with no recording on it is inserted.

, Insert a recorded MD.

• The disc is damaged or does not contain proper recording or

editing data.

, Reinsert the disc. If this fails, rerecord.

• There is no more space to record on the disc (less than 12

seconds in stereo, 24 seconds in LP2 mode or monaural or 48

seconds in LP4 mode available).

, Replace the disc.

• The MD player is recording information (sounds) from the

memory to the disk.

, Wait until this process is completed. Do not expose the

player to any physical shock, nor disrupt power supply.

• The MD player is recording information (track start and end

position) from the memory to the disk.

, Wait until this process is completed. Do not expose the

player to physical shock, nor disrupt power supply.

• You tried to operate the recorder while it was accessing the

recorded data.

, Wait until the message goes out (in rare cases, it may take

2–3 minutes).

• You tried to enter more than 200 letters to label a single track

or disc.

• You tried to enter a total of more than 1,700 letters for track or

disc names during playback or stop.

, Enter the characters within the limit.

• Voltage of the power supply is too high (The recommended

AC power adaptor is not used).

, Use the recommended AC power adaptor.

• The recorder is locked.

, Slide HOLD against the arrow to unlock the recorder

(page 23).

• Battery is weak.

, Replace the dry battery (page 9).

• You tried to record with the recorder placed where it receives

continuous vibration.

, Put the recorder on a stable place, and start recording

again.

-GB