ACU-RITE Mill PWR G2 Pembaruan Perangkat Lunak - Halaman 2

Jelajahi secara online atau unduh pdf Pembaruan Perangkat Lunak untuk Mixer Musik ACU-RITE Mill PWR G2. ACU-RITE Mill PWR G2 3 halaman.
Juga untuk ACU-RITE Mill PWR G2: Pembaruan Perangkat Lunak (7 halaman), Pembaruan Perangkat Lunak (3 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (6 halaman), Pembaruan Perangkat Lunak (5 halaman), Pembaruan Perangkat Lunak (3 halaman), Pembaruan Perangkat Lunak (6 halaman)

MILLPWR

SOFTWARE

UPDATE

The Move Table menu key is now disabled when it should not be used. Previously, pressing it at

certain times, for example immediately after setting a new datum point, could cause unexpected

behavior such as table movement.

Persistent Jog Mode is now canceled when exiting Move Table.

Corrected an issue which prevented system messages and errors from being displayed on the

yellow status bar while the 'Machine Functions' menu was active.

Corrected an issue where the Ring step with a small side finish could have gouging on the

inside radius.

The Z-Axis starts .100" higher than the start "Z" value provided. MPII used .01" instead of .1".



Additional erroneous error were corrected