Cisco ASA 5585-X Panduan Memulai Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco ASA 5585-X. Cisco ASA 5585-X 6 halaman. Maintenance and upgrade procedures
Juga untuk Cisco ASA 5585-X: Panduan Memulai Cepat (40 halaman), Panduan Pemeliharaan (44 halaman)
Halaman Cetak
Cisco ASA 5585-X Quick Start Guide
Slot 0 Module
Management
Interface ID
ASA SSP
Management 0/0
The ASA SSP is
the only
supported
module in slot 0.
All management traffic to and from the non-ASA SSP must enter and exit the Management 1/0 or 1/1 interface.
Because this interface is not an ASA data interface, traffic cannot pass through the ASA over the backplane; you
need to physically cable the management interface to an ASA interface. Non-ASA SSPs usually need Internet
access for updates. See the following typical cabling setup to allow SSP access to the Internet through the ASA
management interface. Other options are possible, depending on how you want to connect your network; for
example, you can make the Management 1/0 interface outside facing; or you can route between it and a different
ASA interface if you have an inside router; and so on.
Layer 2
Switch
Management PC
4. Connect Interface Cables and Verify Connectivity
1.
Cable the management and data interfaces. See
sample cabling scenario.
Default IP
address
192.168.1.1
Module Gateway
to Internet
management
ASA Management 0/0
Module Management 1/0
Set IP to be on same network as M0/0
4. Connect Interface Cables and Verify Connectivity
Slot 1 Module
Management
Interface ID
ASA SSP
Management 0/0
All other SSPs
Management 1/0
ASA
outside
Module
3. Network Considerations for Multiple SSPs, page 2
Default IP
address
192.168.1.1
If you want to put
both ASA SSPs
on the same
network, you
must change
from this default.
Varies. See the
module quick start
guide for exact
values.
Internet
for a
3