Cisco Catalyst 3030 Panduan Memulai - Halaman 19

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Perangkat Keras Jaringan Cisco Catalyst 3030. Cisco Catalyst 3030 34 halaman. Cisco systems catalyst blade switch getting started guide

Halaman Cetak

Cisco Catalyst Blade Switch 3030 Getting Started Guide

Warning

Connect to the Switch Ports

Connect to the 10/100/1000 Ports

Step 1

78-17052-01

Ultimate disposal of this product should be handled according to all national

laws and regulations. Statement 1040

For connections outside the building where the equipment is installed, the

following ports must be connected through an approved network termination

unit with integral circuit protection: 10/100/1000 Ethernet. Statement 1044

Installation of the equipment must comply with local and national electrical

codes. Statement 1074

This section describes how to connect to the fixed switch ports and to the

SFP module ports.

Follow these steps:

The automatic medium-dependent interface crossover (auto-MDIX) feature is

enabled by default on the switch module. When the auto-MDIX feature is enabled,

the switch detects the required cable type for copper Ethernet connections and

configures the interfaces accordingly. (See

Figure

Cisco Catalyst Blade Switch 3030 Getting Started Guide

Installation Warning Statements

7.)

1-19