Cisco Catalyst 3030 시작하기 매뉴얼 - 페이지 19

{카테고리_이름} Cisco Catalyst 3030에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Catalyst 3030 34 페이지. Cisco systems catalyst blade switch getting started guide

페이지 인쇄

Cisco Catalyst Blade Switch 3030 Getting Started Guide

Warning

Connect to the Switch Ports

Connect to the 10/100/1000 Ports

Step 1

78-17052-01

Ultimate disposal of this product should be handled according to all national

laws and regulations. Statement 1040

For connections outside the building where the equipment is installed, the

following ports must be connected through an approved network termination

unit with integral circuit protection: 10/100/1000 Ethernet. Statement 1044

Installation of the equipment must comply with local and national electrical

codes. Statement 1074

This section describes how to connect to the fixed switch ports and to the

SFP module ports.

Follow these steps:

The automatic medium-dependent interface crossover (auto-MDIX) feature is

enabled by default on the switch module. When the auto-MDIX feature is enabled,

the switch detects the required cable type for copper Ethernet connections and

configures the interfaces accordingly. (See

Figure

Cisco Catalyst Blade Switch 3030 Getting Started Guide

Installation Warning Statements

7.)

1-19