Cisco Catalyst 3750-E Series Panduan Memulai - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Perangkat Keras Jaringan Cisco Catalyst 3750-E Series. Cisco Catalyst 3750-E Series 27 halaman. Switches and power supply modules
Juga untuk Cisco Catalyst 3750-E Series: Panduan Memulai (33 halaman), Buletin Dukungan Produk (6 halaman), Buletin Dukungan Produk (5 halaman), Buletin Dukungan Produk (6 halaman), Catatan Instalasi (20 halaman)

Halaman Cetak
Cisco Catalyst 3750-E Series Panduan Memulai
3. Download the Network Assistant installer, and run it. (You can run it directly from the Web if
your browser offers this choice.)
4. When you run the installer, follow the displayed instructions. In the final panel, click Finish to
complete the Network Assistant installation.
Refer to the Network Assistant online help and the getting started guide for more information.
Command-Line Interface
You can enter Cisco IOS commands and parameters through the CLI. Access the CLI by connecting
your PC directly to the switch console port or to the Ethernet management port.

Using the switch console port:

Follow these steps:
1. Connect the supplied RJ-45-to DB-9 adapter cable to the standard 9-pin serial port on the PC.
Connect the other end of the cable to the console port on the switch.
2. Start a terminal-emulation program on the PC.
3. Configure the PC terminal emulation software for 9600 baud, 8 data bits, no parity, 1 stop bit,
and no flow control.
4. Use the CLI to enter commands to configure the switch. See the software configuration guide and
the command reference for more information.
Using the switch Ethernet management port:
Follow these steps:
1. Connect a Category 5 Ethernet cable to the PC Ethernet port. Connect the other end of the cable
to the Ethernet management port on the switch rear panel.
2. Start a Telnet session on the PC.
3. Enter the switch IP address that you assigned by using Express Setup.
4. Use the CLI to enter commands to configure the switch. See the software configuration guide and
the command reference for more information.
10