Cisco Catalyst 3750-E Series Panduan Memulai - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Perangkat Keras Jaringan Cisco Catalyst 3750-E Series. Cisco Catalyst 3750-E Series 27 halaman. Switches and power supply modules
Juga untuk Cisco Catalyst 3750-E Series: Panduan Memulai (33 halaman), Buletin Dukungan Produk (6 halaman), Buletin Dukungan Produk (5 halaman), Buletin Dukungan Produk (6 halaman), Catatan Instalasi (20 halaman)

Resetting the Switch

This section describes how to reset the switch by rerunning Express Setup. These are reasons why you

might want to reset the switch:

• You installed the switch in your network and cannot connect to it because you assigned the

incorrect IP address.

• You want to clear all configuration from the switch and assign a new IP address.

• You are trying to enter Express Setup mode, and the switch LEDs start blinking when you press

the Mode button (which means that the switch is already configured with IP information).

Resetting the switch deletes the configuration and reboots the switch.

Caution

To reset the switch:

• Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue

holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch

reboots.

The switch now behaves like an unconfigured switch. You can enter the switch IP information by using

Express Setup as described in the "Running Express Setup" section on page 4.

Accessing Help Online

First look for a solution to your problem in the troubleshooting section of the hardware installation

guide or the software configuration guide on Cisco.com. You can also access the Cisco Technical

Support and Documentation website for a list of known hardware problems and extensive

troubleshooting documentation.