Cisco IAD2430 Series Panduan Memulai Cepat - Halaman 16
Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perangkat Keras Jaringan Cisco IAD2430 Series. Cisco IAD2430 Series 34 halaman. Integrated access device
Juga untuk Cisco IAD2430 Series: Panduan Ikhtisar (13 halaman), Ikhtisar (16 halaman)
Halaman Cetak
Figure 14
Mounting-Screw Slots for Wall-Mounting the Cisco IAD2435 IAD
1
2
1
1
Rubber feet
The following conditions must be met when you mount the router:
• Because you will use the LEDs as status and problem indicators, the LEDs on the front panel must face upward and must
be easily visible.
• The back panel must face downward to reduce strain on the cable connections.
• The power supply must rest on a horizontal surface such as the floor or a table. If the power supply is not supported, it
could place strain on the power supply cable and cause it to disconnect from the connector on the router back panel.
To wall-mount a Cisco IAD2435 IAD, follow these steps:
Step 1
Secure two screws 7 inches (17.78 centimeters) apart into a wall and 5/32 inch (0.40 centimeter) from the wall.
Hang the router on the screws as shown in Figure 15.
Step 2
Place the power supply on a horizontal surface.
Step 3
16
1
2
1
2
Mounting-screw slots