Digitrax DN166I1C Panduan Memulai Cepat - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Pengontrol Digitrax DN166I1C. Digitrax DN166I1C 8 halaman. Complete train control

Halaman Cetak

Parts List

1 DN166I1C Mobile Decoder

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Installation Instructions

Carefully remove the locomotive's

shell from the frame by inserting

two toothpicks under the unit's

ladders as shown.

Once you've positioned the tooth-

picks, grasp the frame and tooth-

picks with one hand and the loco-

motive's shell with the other hand

and carefully separate the two.

Once the shell is off, remove the

existing light board by removing the

two screws located on the diagonal

corners of the board. The final step

in removing the light board is to

carefully unsolder the two wires

leading from the headlight assem-

bly.

Take the new DN166I1C decoder

and place it on top of the frame.

Note proper orientation. The decod-

er's brass motor contacts should fit

in the frame slot as shown.

Solder headlight leads to the new

decoder board as shown If you were

sitting in the cab, the yellow lead

would be on your left and the green

lead would be on your right. The

final step is to secure the decoder

with the original screws. Note: the locomotive's frame halves may have to be

loosened slightly to achieve proper alignment.

Figure 1: Insert

toothpicks as

shown

Figure 3: Unscrew, unsolder

and remove standard lightboard

— 2 —

1 Instruction Sheet

Tooth-

picks

inserted

under

center of

body

Figure 2:

Remove shell

from frame.

Board shown

partially

removed.