Digitrax UT4 Series Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pengontrol Digitrax UT4 Series. Digitrax UT4 Series 4 halaman.

2 Press and hold the Dispatch key

3 Plug the throttle back into a LocoNet port.

Consists

If the loco you select is the top loco in a consist, you have complete control

over the consist. If you select a loco within an existing consist, only the func-

tion keys (F0-F12) are active. You will not have throttle, forward/reverse or

brake control. When you've successfully selected a consist, the status light will

faintly blink green approximately once a second. This is normal.

The Function Keys

There are 8 physical keys assigned for functions F0-F12. The blue F7-F12

function keys share the same 'keys' as the F1 through F6 function keys. To use

functions F7-F12 you must press and hold down the SHIFT key on the lower

left row as you push the F7 through F12 key. All the UT4 functions work like

other Digitrax throttles. The function keys toggle on and off with each press,

except for F2, which is ON only when held down, and OFF when released. In

Addition, the F2 key has a 'Hold' feature for those who may need F2 to stay

on. The 'Hold' feature can be set by holding the F2 key down for 15 seconds.

Tapping it again turns it off.

Infrared Operation

The UT4 comes InfraReady for layouts that are equipped with one or more

UR90 infrared receivers. For Infrared operation

1 Install a 9 volt battery into the unit.

2 With the UT4 unplugged, dial up the 2 or 4 digit address using the 4 rotary

address selectors .

3 Plug the UT4 into the LocoNet port and wait until the green status light

appears (typically 1-3 seconds)

4 Then simply unplug the UT4 from the Loconet port

The throttle will automatically shift into infrared operation. In infrared mode

you will be able to control:

Throttle speed

Direction, Brake and,

Functions F0-F8

2443 Transmitter RD

Panama City, FL 32404