Digitrax PM42 Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Unit Kontrol Digitrax PM42. Digitrax PM42 16 halaman.

5.3 Setting the PM42 for Auto-Reversing Operation

Once you have wired one or more sections of the PM42 for auto-reversing

according to the instructions in Section 4.0 of this manual, use TABLE V

below to determine which OpSw you must set to enable auto-reversing in the

PM42 section/s you want to use as auto-reversing.

We recommend that you set your short circuit detection sensitivity to the

"Fastest" setting when using auto-reversing.

TABLE V: PM42 Auto-Reversing Set Up Option Switches

PM42

Section 1

PM42

Section 2

PM42

Section 3

PM42

Section 4

The PM42 will operate with no connection to LocoNet. To put your PM42 on

LocoNet, use the two LocoNet connectors on the PM42 to connect it to

LocoNet using 6 conductor cables just like any other LocoNet device on your

layout.

If connected to LocoNet, the PM42 sends information to the system as faults

are detected, cleared, and when auto-reversing occurs. If you wish to report

PM42 status information to LocoNet and attached devices or computers that

can interpret these messages, you must set up a unique board address for each

PM42.

1. Connect a Digitrax DT series throttle to the LocoNet port on your

PM42.

2. If the PM42 is not connected to a working LocoNet (via a 6 conduc-

OpSw 06 = c

Connect Rail A, Pins E & 5,

Connect Rail B, Pins F & 6

on 44-pin connector

OpSw 14 = c

Connect Rail A, Pins K & 9,

Connect Rail B, Pins I & 10

on 44-pin connector

OpSw 22 = c

Connect Rail A, Pins P & 13,

Connect Rail B, Pins R & 14

on 44-pin connector

OpSw 30 = c

Connect Rail A, Pins U & 17,

Connect Rail B, Pins V & 18

on 44-pin connector