AcueLighting Extreme 150 Hybrid Buku Petunjuk - Halaman 3

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Pencahayaan AcueLighting Extreme 150 Hybrid. AcueLighting Extreme 150 Hybrid 11 halaman.

Halaman Cetak

Thank you for choosing Acue Lighting Products

For your safety and the safety of others, do not modify this product in any way. Please note that damage

caused by improper use, regular wear and tare, and misconduct with the product is beyond the scope of our

warranty. Warranty only covers manufacturers defects for the amount of 1 year from purchase.

This equipment has passed strict testing and inspection before shipment. Please refer to the instruction manual's

section under operation requirements (section 5), to ensure the safe operation of the product under normal

conditions. Any damage caused by improper operation will void all warranty claims. Manufacturer does not accept

any liability due to improper operation of its products or non-compliance of the instructions in this manual of any

of any kind.

Please place the manual in a safe place for future reference.

1. Instructions

1.1Application According to Purpose

This product is a stage lighting luminaire, which creates special light effects using an LED light source. To

generate these effects, the product must be connected to a proper power source and a DMX-512 compatible

controller.

This product is designed for 110/230V, 50/60Hz operation and exclusively for indoor use.

If used for any purpose other than described in these operating instructions, the device may suffer damage

and cause the warranty to be void.

The manufacturer's serial number must never be removed as otherwise the warranty will be void.

Safety and Maintenance checks must be done routinely to avoid any damages to the product and the

surroundings.

1.2 Indoor use only

Make sure the equipment load-bearing structure (ceiling, wall, or truss) can withstand the weight of more

than 10 times of fixture when installed above ground.

Disconnect all power input to power supply before replacing lamp, fuse or other accessories

Only operate under proper electrical standards not to overload circuits.

Cool down for 15 minutes before replacing lamps. Please do not use other company's accessories.

Contact your specialized dealer for any technical problems or issues

1.3 Safety operation

Do not operate without outer cover or lenses

Do not look directly to the light

Replace immediately when lamp broken

Do not project directly to items near 0.5M

Do not operate in temperature over 45 °C