Cisco UCS B200 M3 Catatan Instalasi dan Layanan - Halaman 13

Jelajahi secara online atau unduh pdf Catatan Instalasi dan Layanan untuk Perangkat Keras Jaringan Cisco UCS B200 M3. Cisco UCS B200 M3 36 halaman. Blade server
Juga untuk Cisco UCS B200 M3: Panduan Instalasi (34 halaman), Catatan Instalasi dan Layanan (37 halaman), Manual (8 halaman), Panduan Peningkatan (21 halaman), Catatan Instalasi dan Layanan (28 halaman)

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown

Caution

of the operating system.

•

If you are shutting down all blade servers in a chassis, you should now disconnect the power cords from

Step 3

the chassis to completely power off the servers. If you are only shutting down one server, you can skip

unplugging the chassis and move to removing the server.

Removing a Cisco UCS B200 M3 Blade Server

Using UCS Manager, decommission the server before physically removing the server. To remove a blade

server from the chassis, follow these steps:

Loosen the captive screw on the front of the blade.

Step 1

Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade

Step 2

server.

Slide the blade part of the way out of the chassis, and place your other hand under the blade to support

Step 3

its weight.

Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately

Step 4

reinstalling it into another slot.

If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.

Step 5

Installing a Cisco UCS B200 M3 Blade Server

UCS B200 M3 blade servers are interoperable in a UCS chassis with any other UCS blade servers,

including prior generation B200 M2 and B200 M1 servers, or other UCS B-Series blade servers. To

install a blade server, follow these steps:

Grasp the front of the blade server and place your other hand under the blade to support it. See

Step 1

OL-26624-01

Graceful shutdown—Press and release the Power button. The operating system performs a graceful

shutdown and the server goes to standby mode, which is indicated by an amber Power Status LED.

Emergency shutdown—Press and hold the Power button for 4 seconds to force the main power off

and immediately enter standby mode.

Removing and Installing a UCS B200 M3 Blade Server

Cisco UCS B200 M3 Blade Server Installation and Service Note

Figure