Cisco UCS B200 M3 설치 및 서비스 참고 사항 - 페이지 13

{카테고리_이름} Cisco UCS B200 M3에 대한 설치 및 서비스 참고 사항을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco UCS B200 M3 36 페이지. Blade server
Cisco UCS B200 M3에 대해서도 마찬가지입니다: 설치 매뉴얼 (34 페이지), 설치 및 서비스 참고 사항 (37 페이지), 매뉴얼 (8 페이지), 업그레이드 매뉴얼 (21 페이지), 설치 및 서비스 참고 사항 (28 페이지)

S e n d d o c u m e n t c o m m e n t s t o u c s - d o c f e e d b a c k @ c i s c o . c o m

To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown

Caution

of the operating system.

•

If you are shutting down all blade servers in a chassis, you should now disconnect the power cords from

Step 3

the chassis to completely power off the servers. If you are only shutting down one server, you can skip

unplugging the chassis and move to removing the server.

Removing a Cisco UCS B200 M3 Blade Server

Using UCS Manager, decommission the server before physically removing the server. To remove a blade

server from the chassis, follow these steps:

Loosen the captive screw on the front of the blade.

Step 1

Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade

Step 2

server.

Slide the blade part of the way out of the chassis, and place your other hand under the blade to support

Step 3

its weight.

Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately

Step 4

reinstalling it into another slot.

If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.

Step 5

Installing a Cisco UCS B200 M3 Blade Server

UCS B200 M3 blade servers are interoperable in a UCS chassis with any other UCS blade servers,

including prior generation B200 M2 and B200 M1 servers, or other UCS B-Series blade servers. To

install a blade server, follow these steps:

Grasp the front of the blade server and place your other hand under the blade to support it. See

Step 1

OL-26624-01

Graceful shutdown—Press and release the Power button. The operating system performs a graceful

shutdown and the server goes to standby mode, which is indicated by an amber Power Status LED.

Emergency shutdown—Press and hold the Power button for 4 seconds to force the main power off

and immediately enter standby mode.

Removing and Installing a UCS B200 M3 Blade Server

Cisco UCS B200 M3 Blade Server Installation and Service Note

Figure