Cisco 7513 Series Panduan Memulai Cepat - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Server Cisco 7513 Series. Cisco 7513 Series 44 halaman. Chassis replacement
Juga untuk Cisco 7513 Series: Manual Petunjuk Penggantian (26 halaman), Lembar data (11 halaman), Manual (30 halaman), Mempertahankan (20 halaman), Manual Petunjuk Penggantian (19 halaman), Manual Petunjuk Penggantian (22 halaman)

Install the Hardware

Secure the Spacers

Step 1

Loosen the 10-32 x 5/8-inch LG Phillips

pan-head screw at the end of the ledge of

the right-side bracket. This screw is the

anchor for the spanner bar.

Step 2

Remove the tape that secures the spanner

bar on the left bracket, and swing the bar

down (see A) over the anchor screw on the

opposite bracket (see B).

Step 3

If the spanner bar does not reach the

opposite bracket, loosen the pan-head

screws to allow more play between the

brackets, and adjust brackets as needed.

Step 4

Repeat Step 1 through Step 3 to fasten the

remaining spanner bar to its anchor screw.

(See C.)

Step 5

Push the brackets as far apart as possible

before tightening the screws.

Step 6

Use a Number 2 Phillips screwdriver to

tighten the six pan-head screws that

secure the brackets to the rack-mounting

posts, and the two anchor screws that

secure the spanner bars.

Step 7

Adjust the brackets if the distance

between them is less than 17.5 inches

(44.45 cm).