Cisco 7513 Series Краткое руководство по эксплуатации - Страница 8

Просмотреть онлайн или скачать pdf Краткое руководство по эксплуатации для Сервер Cisco 7513 Series. Cisco 7513 Series 44 страницы. Chassis replacement
Также для Cisco 7513 Series: Инструкции по замене Руководство (26 страниц), Информационный лист (11 страниц), Руководство (30 страниц), Поддержание (20 страниц), Инструкции по замене Руководство (19 страниц), Инструкции по замене Руководство (22 страниц)

Cisco 7513 Series Краткое руководство по эксплуатации
Install the Hardware
Secure the Spacers
6
Step 1
Loosen the 10-32 x 5/8-inch LG Phillips
pan-head screw at the end of the ledge of
the right-side bracket. This screw is the
anchor for the spanner bar.
Step 2
Remove the tape that secures the spanner
bar on the left bracket, and swing the bar
down (see A) over the anchor screw on the
opposite bracket (see B).
Step 3
If the spanner bar does not reach the
opposite bracket, loosen the pan-head
screws to allow more play between the
brackets, and adjust brackets as needed.
Step 4
Repeat Step 1 through Step 3 to fasten the
remaining spanner bar to its anchor screw.
(See C.)
A
C
B
Step 5
Push the brackets as far apart as possible
before tightening the screws.
Step 6
Use a Number 2 Phillips screwdriver to
tighten the six pan-head screws that
secure the brackets to the rack-mounting
posts, and the two anchor screws that
secure the spanner bars.
Step 7
Adjust the brackets if the distance
between them is less than 17.5 inches
(44.45 cm).