Cisco Nexus 7000 Series Panduan Konfigurasi - Halaman 17

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Cisco Nexus 7000 Series. Cisco Nexus 7000 Series 28 halaman. Switch chassis
Juga untuk Cisco Nexus 7000 Series: Panduan Referensi (2 halaman), Panduan Petunjuk Instalasi (39 halaman), Referensi (34 halaman), Panduan Instalasi (18 halaman), Mengkonfigurasi (8 halaman), Panduan Memulai Cepat (10 halaman), Panduan Memulai Cepat (29 halaman), Manual Petunjuk Penggantian (14 halaman), Manual Petunjuk Penggantian (21 halaman), Panduan Instalasi (16 halaman), Panduan Pemecahan Masalah (10 halaman)

Configuring the Catena Solution

Configuring a VLAN Group

Before You Begin

Enable the Catena solution. For details about how to enable this, see

Solution."

Procedure

Step 1

Enter global configuration mode:

switch# configure terminal

Step 2

Create a VLAN group and enter VLAN group configuration mode:

switch(config)# catena vlan-group vlan-group-name

Step 3

Assign VLAN to the configured VLAN group (repeat this step to specify all VLANs):

switch(config-vlan-group)# vlan vlan-range

Configuring a Device Group

A device group contains a list of node IP addresses. If you are creating a Layer 3 routed mode deployment

you must create a device group.

Execute this command in the CLI config mode to create or delete a device group.

Note

If there are multiple nodes, then traffic is load balanced accordingly.

Before You Begin

Enable the Catena solution. For details about how to enable this, see

Solution."

Procedure

Step 1

Enter global configuration mode:

switch# configure terminal

Step 2

Create a device group and enter device-group configuration mode:

switch(config)# catena device-group device-group-name

Step 3

Assign nodes to the configured device group:

switch(config-device-group)# node {ip ipv4-address | IPv6 ipv6-address}

Cisco Nexus 7000 Series Switches Configuration Guide: The Catena Solution

Configuring a VLAN Group

"Enabling or Disabling the Catena