Cisco Nexus 7000 Series 구성 매뉴얼 - 페이지 17

{카테고리_이름} Cisco Nexus 7000 Series에 대한 구성 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 7000 Series 28 페이지. Switch chassis
Cisco Nexus 7000 Series에 대해서도 마찬가지입니다: 참조 매뉴얼 (2 페이지), 설치 지침 매뉴얼 (39 페이지), 참조 (34 페이지), 설치 매뉴얼 (18 페이지), 구성 (8 페이지), 빠른 시작 매뉴얼 (10 페이지), 빠른 시작 매뉴얼 (29 페이지), 교체 지침 매뉴얼 (14 페이지), 교체 지침 매뉴얼 (21 페이지), 설치 매뉴얼 (16 페이지), 문제 해결 매뉴얼 (10 페이지)

Configuring the Catena Solution

Configuring a VLAN Group

Before You Begin

Enable the Catena solution. For details about how to enable this, see

Solution."

Procedure

Step 1

Enter global configuration mode:

switch# configure terminal

Step 2

Create a VLAN group and enter VLAN group configuration mode:

switch(config)# catena vlan-group vlan-group-name

Step 3

Assign VLAN to the configured VLAN group (repeat this step to specify all VLANs):

switch(config-vlan-group)# vlan vlan-range

Configuring a Device Group

A device group contains a list of node IP addresses. If you are creating a Layer 3 routed mode deployment

you must create a device group.

Execute this command in the CLI config mode to create or delete a device group.

Note

If there are multiple nodes, then traffic is load balanced accordingly.

Before You Begin

Enable the Catena solution. For details about how to enable this, see

Solution."

Procedure

Step 1

Enter global configuration mode:

switch# configure terminal

Step 2

Create a device group and enter device-group configuration mode:

switch(config)# catena device-group device-group-name

Step 3

Assign nodes to the configured device group:

switch(config-device-group)# node {ip ipv4-address | IPv6 ipv6-address}

Cisco Nexus 7000 Series Switches Configuration Guide: The Catena Solution

Configuring a VLAN Group

"Enabling or Disabling the Catena