Cisco ONS 15600 Mengubah Pengaturan Kartu - Halaman 3
Jelajahi secara online atau unduh pdf Mengubah Pengaturan Kartu untuk Server Cisco ONS 15600. Cisco ONS 15600 14 halaman. Install the bay and backplane connections
Juga untuk Cisco ONS 15600: Panduan Referensi (29 halaman), Manual (10 halaman), Panduan Referensi (22 halaman), Panduan Petunjuk Instalasi (14 halaman)
Halaman Cetak
Chapter 11
Change Card Settings
NTP-E151 Provision an Optical Line Rate
Purpose
Tools/Equipment
Prerequisite Procedures
Required/As Needed
Onsite/Remote
Security Level
Complete the
Step 1
Click the Alarms tab:
Step 2
a.
b.
c.
In node view, double-click the ASAP card where you want to provision the line rate.
Step 3
Click the Provisioning > Pluggable Port Modules tabs.
Step 4
In the Pluggable Ports pane, click Create. The Create Port dialog box appears.
Step 5
In the Create Port dialog box, complete the following:
Step 6
•
•
Click OK.
Step 7
Repeat Steps
Step 8
Table 11-1
Card
ASAP
February 2008
This procedure provisions the line rate on a multirate pluggable port
module (PPM). Single-rate small-form factor pluggables (SFPs) or 4-port
I/O modules (4PIOs) do not need line rate provisioning.
None
NTP-E148 Preprovision an SFP Slot, page 2-8
NTP-E157 Provision a Multirate PPM, page 11-2
Required
Onsite or remote
Provisioning or higher
"DLP-E26 Log into CTC" task on page 16-39
Verify that the alarm filter is not turned on. See the
page 17-50
as necessary.
Verify that no unexplained conditions appear on the network. If unexplained conditions appear,
resolve them before continuing. Refer to the Cisco ONS 15600 SONET Troubleshooting Guide.
Complete the
"DLP-E76 Export CTC Data" task on page 16-98
information.
Port—Click the PPM number and port number from the drop-down list. The first number indicates
the PPM and the second number indicates the port number on the PPM. For example, the first PPM
with one port displays as 1-1 and the second PPM with one port displays as 2-1. When a 4PIO is
present on an ASAP card, the port is identified as 4PIO#-PPM#-Port# (for example 4-4-1). The 4PIO
number can be 1 to 4, the PPM number can be 1 to 4, but the port number is always 1.
Port Type—Click the type of port from the drop-down list. The port type menu displays the
supported port rates on your PPM. See
card.
5
through
7
to configure the port rates as needed.
PPM Port Types
to log into an ONS 15600 on the network.
"DLP-E157 Disable Alarm Filtering" task on
Table 11-1
for definitions of the supported rates on the ASAP
Port Type
OC-3—155 Mbps
•
OC-12—622 Mbps
•
OC-48—2.48 Gbps
•
ETHER—10 Gbps Ethernet
•
Cisco ONS 15600 Procedure Guide, R5.0
NTP-E151 Provision an Optical Line Rate
or
to export alarm and condition
11-3