Cisco S695F Panduan Memulai - Halaman 13

Jelajahi secara online atau unduh pdf Panduan Memulai untuk Server Cisco S695F. Cisco S695F 18 halaman. Web security appliance
Juga untuk Cisco S695F: Manual (24 halaman), Panduan Pemasangan Perangkat Keras (50 halaman)

Halaman Cetak

Power up the appliance by pressing the On/Off switch on the front panel of the appliance. You must

Step 5

wait 10 minutes for the system to initialize each time you power up the system. After the appliance

powers up, a solid green light on the front panel indicates that the appliance is operational.

Wait at least 10 minutes for the system to complete the power up sequence and the LEDs to turn green.

Caution

If you turn the power off before the initialization is complete, the appliance will not reach an operational

state and must be returned to Cisco.

If turned on quickly after connecting power to the appliance, the appliance powers up, the fans spin and

Note

the LEDs turn on. Within 30-60 seconds, the fans stop and all LEDs turn off. The appliance powers on

31 seconds later. This behavior is by design to allow the system firmware and controller to synchronize.

See the

Step 6

Log In to the Appliance

You can log into the Cisco Web Security Appliance using one of two interfaces

the CLI.

•

For web browser access through the Ethernet port (see the

Step 1

page

http://192.168.42.42:8080

Enter the following login information:

Step 2

•

The hostname parameter is assigned during system setup. Before you can connect to the management

Note

interface using a hostname (http://hostname:8080), you must add the appliance hostname and IP address

to your DNS server database.

Click Login.

Step 3

Management port (M1) - (192.168.42.42)

Traffic monitor port (T1)

Internet

AsyncOS for Cisco Web Security Appliances User Guide

7), go to the appliance management interface by entering the following URL in a web browser:

Username: admin

Password: ironport

Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide

Management computer (192.168.42.43)

WAN modem

for further configuration.

"Connect to the Appliance" section on

–

the web interface or