Cisco S695F Başlangıç Kılavuzu - Sayfa 13
Sunucu Cisco S695F için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco S695F 18 sayfaları. Web security appliance
Ayrıca Cisco S695F için: Manuel (24 sayfalar), Donanım Kurulum Kılavuzu (50 sayfalar)
1
3
5
Power up the appliance by pressing the On/Off switch on the front panel of the appliance. You must
Step 5
wait 10 minutes for the system to initialize each time you power up the system. After the appliance
powers up, a solid green light on the front panel indicates that the appliance is operational.
Wait at least 10 minutes for the system to complete the power up sequence and the LEDs to turn green.
Caution
If you turn the power off before the initialization is complete, the appliance will not reach an operational
state and must be returned to Cisco.
If turned on quickly after connecting power to the appliance, the appliance powers up, the fans spin and
Note
the LEDs turn on. Within 30-60 seconds, the fans stop and all LEDs turn off. The appliance powers on
31 seconds later. This behavior is by design to allow the system firmware and controller to synchronize.
See the
Step 6
Log In to the Appliance
You can log into the Cisco Web Security Appliance using one of two interfaces
the CLI.
•
•
Log In to the Appliance Using the Web Interface
For web browser access through the Ethernet port (see the
Step 1
page
http://192.168.42.42:8080
Enter the following login information:
Step 2
•
•
The hostname parameter is assigned during system setup. Before you can connect to the management
Note
interface using a hostname (http://hostname:8080), you must add the appliance hostname and IP address
to your DNS server database.
Click Login.
Step 3
Management port (M1) - (192.168.42.42)
Traffic monitor port (T1)
Internet
AsyncOS for Cisco Web Security Appliances User Guide
Log In to the Appliance Using the Web Interface, page 13
Log In to the Appliance Using the CLI, page 14
7), go to the appliance management interface by entering the following URL in a web browser:
Username: admin
Password: ironport
Cisco Web Security Appliance S195, S395, S695, and S695F Getting Started Guide
2
Management computer (192.168.42.43)
4
WAN modem
for further configuration.
"Connect to the Appliance" section on
Log In to the Appliance
–
the web interface or
13