Cisco SCE8000 GBE Panduan Konfigurasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Cisco SCE8000 GBE. Cisco SCE8000 GBE 18 halaman. 10gbe platform
Juga untuk Cisco SCE8000 GBE: Panduan Memulai Cepat (25 halaman), Prosedur Penghapusan dan Penggantian (36 halaman), Menginstal (21 halaman)

Halaman Cetak
Cisco SCE8000 GBE Panduan Konfigurasi
Chapter 2
Introduction to the Cisco SCE8000 10GBE Platform

Service Control Module (SCE8000-SCM-E)

The Cisco SCE8000 contains one or two SCE8000-SCMs located in slots#1 and #2 (the top two slots).
The Service Control module contains ports and LEDs as shown in
Table
Figure 2-2
SCE8000-SCM-E
Table 2-2
Port
10/100/1000
Console
AUX
Optical Bypass 2
OL-16478-05
2-3.
SCE8000-SCM-E
OPTICAL
CONSOLE
PORT1
BYPASS1
10/100/
LINK/
1000
ACTIVE
SCE8000-SCM-E Ports
Quantity
2 (Port1 and
Port2)
Currently only
Port1 is
supported.
1
1
STATUS
OPTICAL BYPASS
OPTICAL
AUX
PORT2
BYPASS2
10/100/
LINK/
1000
ACTIVE
Description
10/100/1000 Ethernet RJ-45
ports for management of the
Cisco SCE8000.
CLI designation: interface
GigabitEthernet 1/1, 1/2.
RS-232 RJ-45 port for use by
technicians
RS-232 RJ-45 port used by
technicians
RJ-11 port
Cisco SCE8000 10GBE Installation and Configuration Guide
Service Control Module (SCE8000-SCM-E)
Figure 2-2
and
Table 2-2
and
SCE8000 EXTENDED SERVICE CONTROL MODULE
MASTER
SYSTEM POWER
Connect This Port To...
A LAN using a GBE cable with
an RJ-45 connector.
A local terminal (console) using
an RS-232 cable with an RJ-45
connector, as provided in the
Cisco SCE8000 kit.
The Control connector on the
optical bypass module.
2-3