Cisco SCE8000 GBE Panduan Konfigurasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Konfigurasi untuk Server Cisco SCE8000 GBE. Cisco SCE8000 GBE 18 halaman. 10gbe platform
Juga untuk Cisco SCE8000 GBE: Panduan Memulai Cepat (25 halaman), Prosedur Penghapusan dan Penggantian (36 halaman), Menginstal (21 halaman)
Halaman Cetak
Service Control Module (SCE8000-SCM-E)
Table 2-3
LEDs
System Power
Status
Optical Bypass
Master
Port1 and Port2
(Management
interfaces)
Cisco SCE8000 10GBE Installation and Configuration Guide
2-4
SCE8000-SCM-E LEDs
Description
•
Steady green — Installed power supplies are functioning normally.
•
Steady amber — Only one power supply is functioning normally.
•
Unlit — No power from either power supply.
On a slave SCE8000-SMC_E module (in the second slot), this LED is always off.
The Status LED indicates the operational status of the Cisco SCE8000 system, as
follows:
Unlit — No power from either power unit.
•
Steady amber — The system is booting up.
•
Flashing amber — The system is operational, but is in a warning state.
•
Flashing green — The system is fully operational.
•
Steady red — There is a problem or failure
•
Alarms are hierarchical: Failure takes precedence over Warning, which
Note
takes precedence over Operational.
Steady amber — The optic bypass module has been directed to pass traffic via
•
the Cisco SCE8000.
Unlit — The optic bypass module (if present) will connect the link fibers
•
directly, and traffic will bypass the Cisco SCE8000.
On a slave SCE8000-SMC_E module (in the second slot), this LED is always off.
This functionality is consistent even when the Cisco SCE8000 is powered
Note
down.
Indicates the master Service Control module
Steady green — Master Service Control module
•
Unlit — Slave Service Control module
•
The Port1 and Port2 LEDs indicate the operational status of the Cisco SCE8000
out-of-band LAN-based management port, as follows:
•
Link/Active
Steady green — Port link is up
Flashing green — Activity on the port link
Unlit — Port link is down
Speed
•
Unlit — Port is set to 10Mbps
Steady green — Port is set to 100 Mbps
Steady amber — Port is set to 1000 Mbps
On a slave SCE8000-SMC-E module (in the second slot), this LED is always off.
Chapter 2
Introduction to the Cisco SCE8000 10GBE Platform
OL-16478-05