Cisco SNS 3595 Panduan Instalasi - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Server Cisco SNS 3595. Cisco SNS 3595 36 halaman.

Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances

Step 2

Connect one end of the cable to the GigabitEthernet 0 port on the appliance.

Step 3

Connect the other end to a switch in your network.

Ethernet Port Connector

The Cisco SNS 3515 or Cisco SNS-3595 appliance comes with six integrated dual-port Ethernet controllers.

The controllers provide an interface for connecting to 10-Mb/s, 100-Mb/s, or 1000-Mb/s networks and provide

full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the Ethernet

LAN. Cisco ISE supports multiple NICs.

To access the Ethernet port, connect a Category 3, 4, 5, 5E, or 6 unshielded twisted-pair (UTP) cable to the

RJ-45 connector on the back of the appliance.

The following table describes the UTP cable categories.

Type

10BASE-T

100BASE-TX

1000BASE-T

The following figure shows the RJ-45 port and plug.

Figure 10: RJ-45 Port and Plug

Ethernet Port Pin-out

Ethernet Port

Signal

Description

TxD+

Transmit data +

TxD-

Transmit data -

RxD+

Receive data +

Termination

No connection

network

Termination

No connection

network

RxD-

Receive data-

Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide

Description

EIA Categories 3, 4, or 5 UTP (2 or 4 pair) up to 328

ft (100 m)

EIA Category 5 UTP (2 pair) up to 328 ft (100 m)

EIA Category 6 UTP (recommended), Category 5E

UTP or 5 UTP (2 pair) up to 328 ft (100 m)

Ethernet Port Connector