Cisco SNS 3595 Installatiehandleiding - Pagina 25

Blader online of download pdf Installatiehandleiding voor {categorie_naam} Cisco SNS 3595. Cisco SNS 3595 36 pagina's.

Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances

Step 2

Connect one end of the cable to the GigabitEthernet 0 port on the appliance.

Step 3

Connect the other end to a switch in your network.

Ethernet Port Connector

The Cisco SNS 3515 or Cisco SNS-3595 appliance comes with six integrated dual-port Ethernet controllers.

The controllers provide an interface for connecting to 10-Mb/s, 100-Mb/s, or 1000-Mb/s networks and provide

full-duplex (FDX) capability, which enables simultaneous transmission and reception of data on the Ethernet

LAN. Cisco ISE supports multiple NICs.

To access the Ethernet port, connect a Category 3, 4, 5, 5E, or 6 unshielded twisted-pair (UTP) cable to the

RJ-45 connector on the back of the appliance.

The following table describes the UTP cable categories.

Type

10BASE-T

100BASE-TX

1000BASE-T

The following figure shows the RJ-45 port and plug.

Figure 10: RJ-45 Port and Plug

Ethernet Port Pin-out

Ethernet Port

Signal

Description

TxD+

Transmit data +

TxD-

Transmit data -

RxD+

Receive data +

Termination

No connection

network

Termination

No connection

network

RxD-

Receive data-

Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide

Description

EIA Categories 3, 4, or 5 UTP (2 or 4 pair) up to 328

ft (100 m)

EIA Category 5 UTP (2 pair) up to 328 ft (100 m)

EIA Category 6 UTP (recommended), Category 5E

UTP or 5 UTP (2 pair) up to 328 ft (100 m)

Ethernet Port Connector