Cisco UCS B200 M4 Catatan Instalasi dan Layanan - Halaman 10
Jelajahi secara online atau unduh pdf Catatan Instalasi dan Layanan untuk Server Cisco UCS B200 M4. Cisco UCS B200 M4 30 halaman. For e5-2600 v4 series cpus
Juga untuk Cisco UCS B200 M4: Catatan Instalasi dan Layanan (46 halaman), Panduan Peningkatan (9 halaman), Panduan Servis (24 halaman)
Halaman Cetak
The operating system performs a graceful shutdown and the server goes to standby mode.
Caution
To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown of the
operating system.
Step 3
(Optional) If you are shutting down all blade servers in a chassis, disconnect the power cords from the chassis to completely
power off the servers.
Step 4
Remove the appropriate servers from the chassis.
Removing a Blade Server
Using UCS Manager, decommission the server before physically removing the server. To remove a blade server from the chassis,
follow these steps:
Procedure
Step 1
Loosen the captive screw on the front of the blade.
Step 2
Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade server.
Step 3
Slide the blade part of the way out of the chassis, and place your other hand under the blade to support its weight.
Step 4
Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately reinstalling it into another
slot.
Step 5
If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.
Installing a Half-width Blade Server
UCS B200 M4, UCS B200 M3, and UCS B22 M3 half-width blade servers are interoperable in a UCS chassis with any other UCS
blade servers, including prior generation B200 M2 and B200 M1 servers, or other UCS B-Series blade servers. To install a half-width
blade server, follow these steps:
10