Cisco UCS B200 M4 Nota di installazione e manutenzione - Pagina 10

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B200 M4. Cisco UCS B200 M4 30. For e5-2600 v4 series cpus
Anche per Cisco UCS B200 M4: Nota di installazione e manutenzione (46 pagine), Manuale di aggiornamento (9 pagine), Manuale di manutenzione (24 pagine)

The operating system performs a graceful shutdown and the server goes to standby mode.

Caution

To avoid data loss or damage to your operating system, you should always invoke a graceful shutdown of the

operating system.

Step 3

(Optional) If you are shutting down all blade servers in a chassis, disconnect the power cords from the chassis to completely

power off the servers.

Step 4

Remove the appropriate servers from the chassis.

Removing a Blade Server

Using UCS Manager, decommission the server before physically removing the server. To remove a blade server from the chassis,

follow these steps:

Procedure

Step 1

Loosen the captive screw on the front of the blade.

Step 2

Remove the blade from the chassis by pulling the ejector lever on the blade until it unseats the blade server.

Step 3

Slide the blade part of the way out of the chassis, and place your other hand under the blade to support its weight.

Step 4

Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately reinstalling it into another

slot.

Step 5

If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.

Installing a Half-width Blade Server

UCS B200 M4, UCS B200 M3, and UCS B22 M3 half-width blade servers are interoperable in a UCS chassis with any other UCS

blade servers, including prior generation B200 M2 and B200 M1 servers, or other UCS B-Series blade servers. To install a half-width

blade server, follow these steps: