Cisco UCS B200 M4 Nota di installazione e manutenzione - Pagina 9

Sfoglia online o scarica il pdf Nota di installazione e manutenzione per Server Cisco UCS B200 M4. Cisco UCS B200 M4 30. For e5-2600 v4 series cpus
Anche per Cisco UCS B200 M4: Nota di installazione e manutenzione (46 pagine), Manuale di aggiornamento (9 pagine), Manuale di manutenzione (24 pagine)

You can use Cisco UCS Manager to format and configure RAID services. For details, see the Configuration Guide for the

version of Cisco UCS Manager that you are using. The configuration guides are available at the following URL:

www.cisco.com/en/US/products/ps10281/products_installation_and_configuration_guides_list.html

If you need to move a RAID cluster, see the

Removing a Blade Server Hard Drive

To remove a hard drive from a blade server, follow these steps:

Procedure

Step 1

Push the button to release the ejector, and then pull the hard drive from its slot.

Step 2

Place the hard drive on an antistatic mat or antistatic foam if you are not immediately reinstalling it in another server.

Step 3

Install a hard disk drive blank faceplate to keep dust out of the blade server if the slot will remain empty.

Blade Server Removal and Installation

Before performing any internal operations on this blade server, you must remove it from the chassis.

To prevent ESD damage, wear grounding wrist straps during these procedures and handle modules by the

Caution

carrier edges only.

Powering Off Blade Servers Using the Power Button

You can also shut the server down remotely using Cisco UCS Manager. For details, see the Configuration

Tip

Guide for the version of Cisco UCS Manager that you are using. The configuration guides are available

at the following URL:

configuration_guides_list.html

Procedure

Step 1

For each server in the chassis that you want to power off, check the color of the Power Status LED.

• Green indicates that the server is running and must be shut down before it can be safely powered off. Go to Step 2.

• Amber indicates that the server is already in standby mode and can be safely powered off. Go to Step 3.

Step 2

Press and release the Power button, then wait until the Power Status LED changes to amber.

Cisco UCS Manager B-Series Troubleshooting

http://www.cisco.com/en/US/products/ps10281/products_installation_and_

http://

Guide.