Cisco 3700 series Menginstal dan Memformat - Halaman 15
Jelajahi secara online atau unduh pdf Menginstal dan Memformat untuk Gerbang Cisco 3700 series. Cisco 3700 series 34 halaman. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Juga untuk Cisco 3700 series: Petunjuk Peningkatan (30 halaman), Lembar data (8 halaman), Catatan Aplikasi (41 halaman), Panduan Instalasi (12 halaman)
Halaman Cetak
March 2002
Figure 13
Tighten the two captive retention screws; there is one at each edge of the CPU/mainboard.
Step 3
Hold the front panel straight out from the chassis, engage the hinges, and close the front panel. (See
Step 4
Figure
Tighten the two captive screws behind the small access panel at the right-hand edge.
Step 5
Power ON the router.
Step 6
Observe the following precaution if your router uses DC power:
Warning
After wiring the DC power supply, remove the tape from the circuit breaker switch handle and
reinstate power by moving the handle of the circuit breaker to the ON position. To see translations
of the various warnings that appear in this publication, refer to the Regulatory Compliance and
Safety Information document that accompanied this device.
78-13892-03
Inserting Plug-in CPU/Mainboard into a Cisco 3745 Chassis
Captive
retention
screw
14.)
Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards
Internal CompactFlash Memory Card Installation and Removal
Ejector levers
Captive
retention
screw
15