Cisco 3700 series 설치 및 포맷 - 페이지 15

{카테고리_이름} Cisco 3700 series에 대한 설치 및 포맷을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 3700 series 34 페이지. Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Cisco 3700 series에 대해서도 마찬가지입니다: 업그레이드 지침 (30 페이지), 데이터시트 (8 페이지), 애플리케이션 노트 (41 페이지), 설치 매뉴얼 (12 페이지)

페이지 인쇄

March 2002

Figure 13

Tighten the two captive retention screws; there is one at each edge of the CPU/mainboard.

Step 3

Hold the front panel straight out from the chassis, engage the hinges, and close the front panel. (See

Step 4

Figure

Tighten the two captive screws behind the small access panel at the right-hand edge.

Step 5

Power ON the router.

Step 6

Observe the following precaution if your router uses DC power:

Warning

After wiring the DC power supply, remove the tape from the circuit breaker switch handle and

reinstate power by moving the handle of the circuit breaker to the ON position. To see translations

of the various warnings that appear in this publication, refer to the Regulatory Compliance and

Safety Information document that accompanied this device.

78-13892-03

Inserting Plug-in CPU/Mainboard into a Cisco 3745 Chassis

Captive

retention

screw

14.)

Installing and Formatting Cisco 2691, Cisco 3631 and Cisco 3700 CompactFlash Memory Cards

Internal CompactFlash Memory Card Installation and Removal

Ejector levers

Captive

retention

screw