Cisco 450 Panduan Pemasangan Perangkat Keras - Halaman 23

Jelajahi secara online atau unduh pdf Panduan Pemasangan Perangkat Keras untuk Gerbang Cisco 450. Cisco 450 37 halaman. Voice gateway

Installing the Cisco VG450 Voice Gateway

• Screws and anchors for wall-mounting, if required

• ESD-preventive wrist strap

In addition, you might need the following external equipment:

• Console terminal or PC with terminal emulation software

• PC running terminal emulation software for administrative access

• Modem for remote access

• Analog voice RJ-21 cable

• Ethernet switch

• Modem for remote configuration

Unpacking and Inspection

Do not unpack the Cisco VG450 until you are ready to install it. If the installation site is not ready, keep the

chassis in its shipping container to prevent accidental damage.

The Cisco VG450, cables, printed publications, and any optional equipment you ordered might be shipped in

more than one container. When you unpack each shipping container, check the packing list to ensure that you

received all the following items:

• Cisco VG450 Voice Gateway

• Power cord, 6-foot (1.8-meter)

• RJ-45-to-DB-25 adapter cable (labeled Console)

• RJ-45-to-DB-9 adapter cable (labeled Auxiliary)

• Rack-mounting brackets for 19-inch rack (one pair) with screws for attaching to chassis

• Chassis guard for wall-mounting applications

• Grounding lug and fasteners

Inspect all items for shipping damage. If anything appears damaged, or if you encounter problems when

installing or configuring your system, contact a customer service representative.

Installing Cisco VG450 Voice Gateway

SUMMARY STEPS

1. Shut down the electrical power to the slot in the router either by turning off the electrical power to the

router or by issuing the online insertion and removal (OIR) commands. Leave the power cable plugged

in to channel ESD voltages to ground. For more information on OIR, see the "Managing Cisco Enhanced

Services and Network Interface Modules" chapter in the Cisco 4000 Series ISRs Software Configuration

Guide .

2. Remove the blank faceplates installed over the network interface module slot that you intend to use.

• Eight wood screws or other fasteners, for installing the chassis on a wall. An additional starter screw

can be used to facilitate wall-mounting.

Cisco 450 Voice Gateway Hardware Installation Guide

Unpacking and Inspection