Cisco ASR 9000 Series Mengkonfigurasi - Halaman 29

Jelajahi secara online atau unduh pdf Mengkonfigurasi untuk Gerbang Cisco ASR 9000 Series. Cisco ASR 9000 Series 46 halaman. Line card
Juga untuk Cisco ASR 9000 Series: Mengkonfigurasi Pengaturan Jaringan (26 halaman), Panduan Konfigurasi (46 halaman), Panduan Konfigurasi (50 halaman), Manual (24 halaman), Manual (44 halaman), Panduan Referensi Cepat (7 halaman)

Halaman Cetak
Cisco ASR 9000 Series Mengkonfigurasi
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Command or Action
Step 17
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-sonet)# end
or
RP/0/RSP0/CPU0:router(config-sonet)#
commit
Step 18
show controllers sonet interface-path-id
Example:
RP/0/RSP0/CPU0:router# show controllers
sonet 0/1/1/0
Configuring SDH AU-3 Mapped to T3 or E3
This task explains how to configure SDH AU-3 mapped to T3 or E3.
Prerequisites
•
Restrictions
Channelized SDH AU-3 with T3 or E3 mapping is supported on the following SPAs:
•
•
•
SUMMARY STEPS
1.
2.
3.
OL-26061-03
You should know how to configure the SONET controller as specified in the
Clear Channel SONET Controllers"
on the Cisco ASR 9000 Series Router
Cisco 1-Port Channelized OC-48/STM-16 SPA
Cisco 1-Port Channelized OC-3/STM-1 SPA
Cisco 2-Port Channelized OC-12c/DS0 SPA
configure
controller sonet interface-path-id
clock source {internal | line}
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Saves configuration changes.
•
When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
–
router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
Use the commit command to save the configuration changes to
•
the running configuration file and remain within the
configuration session.
Verifies the SONET controller configuration.
section of the
Configuring Clear Channel SONET Controllers
module.
How to Configure Channelized SONET/SDH
"How to Configure
HC-345