Cisco ASR 9000 Series 구성 - 페이지 29
{카테고리_이름} Cisco ASR 9000 Series에 대한 구성을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco ASR 9000 Series 46 페이지. Line card
Cisco ASR 9000 Series에 대해서도 마찬가지입니다: 네트워크 설정 구성 (26 페이지), 구성 매뉴얼 (46 페이지), 구성 매뉴얼 (50 페이지), 매뉴얼 (24 페이지), 매뉴얼 (44 페이지), 빠른 참조 매뉴얼 (7 페이지)
페이지 인쇄
Configuring Channelized SONET/SDH on the Cisco ASR 9000 Series Router
Command or Action
Step 17
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config-sonet)# end
or
RP/0/RSP0/CPU0:router(config-sonet)#
commit
Step 18
show controllers sonet interface-path-id
Example:
RP/0/RSP0/CPU0:router# show controllers
sonet 0/1/1/0
Configuring SDH AU-3 Mapped to T3 or E3
This task explains how to configure SDH AU-3 mapped to T3 or E3.
Prerequisites
•
Restrictions
Channelized SDH AU-3 with T3 or E3 mapping is supported on the following SPAs:
•
•
•
SUMMARY STEPS
1.
2.
3.
OL-26061-03
You should know how to configure the SONET controller as specified in the
Clear Channel SONET Controllers"
on the Cisco ASR 9000 Series Router
Cisco 1-Port Channelized OC-48/STM-16 SPA
Cisco 1-Port Channelized OC-3/STM-1 SPA
Cisco 2-Port Channelized OC-12c/DS0 SPA
configure
controller sonet interface-path-id
clock source {internal | line}
Cisco ASR 9000 Aggregation Services Router Interfaces and Hardware Component Configuration Guide
Purpose
Saves configuration changes.
•
When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
–
Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and
returns the router to EXEC mode.
Entering no exits the configuration session and returns the
–
router to EXEC mode without committing the
configuration changes.
Entering cancel leaves the router in the current
–
configuration session without exiting or committing the
configuration changes.
Use the commit command to save the configuration changes to
•
the running configuration file and remain within the
configuration session.
Verifies the SONET controller configuration.
section of the
Configuring Clear Channel SONET Controllers
module.
How to Configure Channelized SONET/SDH
"How to Configure
HC-345